Graphiques de remplacement recto-verso 1,5 m L x 2,3 m H EuroFit Housse tendue en tissu à enfiler, SANS INSTALLATION

What does this cover fit, and is hardware included?

It is a double-sided slip-on cover cut and sewn for our 5'W x 90"H floor banner EuroFit tension fabric display, SU738, printed full colour on both faces. It is not a universal cover — the fit is specific to that frame, so confirm your hardware before ordering. The frame and carry case are not included; the frame is the durable, expensive half of the display, and this is the half that dates and takes the damage, so a new cover gives you a visually new display for a fraction of a complete kit. No setup charge applies. Five feet by 90 inches is the largest print area in the floor banner range — closer to a wall than a banner, and the version to renew when the panel is the whole display.

How does it go on, and how does it print?

The cover pulls over the assembled frame like a pillowcase and zips closed — no clips, no tools, and no dismantling, so the frame stays built while the artwork changes. That is what makes holding two or three covers for one frame practical. Printing is by dye sublimation into premium stretch polyester, so the ink is bonded into the fibres with nothing to crack or peel and a matte face that does not flare under spotlights, and because the cover tensions as it goes on, folding creases relax out without steaming. Both faces are printed, so a panel in a walkway works on traffic from either direction rather than showing a blank back.